2 PCs (Windows with a terminal emulation program, such as Tera Term).1 Switch (Cisco 2960 with Cisco IOS Release 15.2(2) lanbasek9 image or comparable).1 Router (Cisco 4221 with Cisco IOS XE Release 16.9.S1(config)# sdm prefer dual-ipv4-and-ipv6 default Use the following commands to assign the dual-ipv4-and-ipv6 template as the default SDM template. The new template will be used after reboot even if the configuration is not saved. Verify that SDM is using either the dual-ipv4-and-ipv6 template or the lanbase -routing template. The default bias template used by the Switch Database Manager (SDM) does not provide IPv6 address capabilities. Consult with your Answers for the procedure to i nitializ e and r eload a r outer and s witch. Note : En sure that the routers and switches have been erased and have no startup configurations. Refer to the Router Interface Summary T able at the end of the lab for the correct interface identifiers. Depending on the model and Cisco IOS version, the commands available and the output produced might vary from what is shown in th e labs. Other routers, switches, and Cisco IOS versions can be used. The switches used in the labs are Cisco Catalyst 2960s with Cisco IOS Release 1 5.2(2) (lanbasek9 image). Note : The router s used with CCNA hands-on lab s are Cisco 4221 with Cisco IOS XE Release 1 6.9.4 (universalk9 image). Test your knowledge by trying to configure the devices without referring to the content or previous activities. This lab provides minimal assistance with the actual commands necessary to configure the router. After the configurations have been saved, you will verify your configurations by testing for network connectivity.ДЄfter the devices have been configured and network connectivity has been verified, you will use IOS commands to retrieve information from the devices to answer questions about your network equipment. You will then configure the devices to match the addressing table. In this lab, you will cable the equipment as shown in the topology diagram. This is a comprehensive lab to review previously covered IOS commands.

Part 2: Configure Devices and Verify Connectivity Background / Scenario Part 1: Set Up the Topology and Initialize Devices

Packet tracer labs pdf